The Effect of Termomechanical Treatment
on the Low-Cyclic Fatigue Behavior in an Al–Cu–Mg–Ag Alloy

M. R. Gazizov; Газизов М. Р.; M. Yu. Gazizova; Газизова М. Ю.; I. S. Zuiko; Зуйко И. С.; R. O. Kaibyshev; Кайбышев Р. О.

doi:10.31857/S001532302360034X

The Effect of Termomechanical Treatment on the Low-Cyclic Fatigue Behavior in an Al–Cu–Mg–Ag Alloy

Authors: Gazizov M.R.¹, Gazizova M.Y.¹, Zuiko I.S.¹, Kaibyshev R.O.¹
Affiliations:
1. Belgorod State National Research University (NRU “BelSU”)
Issue: Vol 124, No 5 (2023)
Pages: 434-442
Section: ПРОЧНОСТЬ И ПЛАСТИЧНОСТЬ
URL: https://innoscience.ru/0015-3230/article/view/662918
DOI: https://doi.org/10.31857/S001532302360034X
EDN: https://elibrary.ru/OLOZMQ
ID: 662918

Cite item

Full Text

Open Access
Restricted Access

Access granted
Restricted Access

Subscription Access

Abstract
About the authors
References
Supplementary files
Statistics

Abstract

The mechanical behavior under monotonic and cyclic loadings has been studied in an Al–4.5Cu–0.56Mg–0.77Ag–0.42Mn–0.12Ti–0.05V–0.02Fe (wt %) alloy subjected to thermomechanical treatment (TMT), including a solution heat treatment, quenching in water, uniaxial tension with a plastic strain of 3%, and
peak aging at 190°C (state T83 according to the classification of the Aluminum Association). The T83-ed alloy demonstrates the lowest tensile strength properties in comparison with T6 state (traditional aging) and TMT,
including rolling with a 40%-reduction (T840). Compared to T6 and T840 states, the lowest cyclic strength and cyclic strain hardening coefficients in the Ramberg-Osgood relationship was found to be in T83-ed alloy. To achieve long fatigue life, it is advisable to reduce to the minimum values the degree of intermediate plastic deformation required for straightening Al–Cu–Mg–Ag sheets after their buckling during high-temperature heating for quenching.

Keywords

Al-Cu-Mg-Ag alloy, thermomechanical treatment, microstructure, mechanical properties, fatigue

References

Polmear I.J., Pons G., Barbaux Y., Octor H., Sanchez C., Morton A.J., Borbidge W.E., Rogers S. After Concorde: Evaluation of creep resistant Al–Cu–Mg–Ag alloys // Mater. Sci. Technol. 1999. V. 15. P. 861–868.
Gazizov M., Kaibyshev R. Low-cyclic fatigue behaviour of an Al–Cu–Mg–Ag alloy under T6 and T840 conditions // Mater. Sci. Technol. 2017. V. 33. P. 688–698.
Газизов М.Р., Кайбышев Р.О. Кинетика и механизм разрушения при циклическом нагружении Al–Cu–Mg–Ag сплава //ФММ. 2016. Т. 117. № 7. С. 748–757.
Gazizov M., Zuiko I., Kaibyshev R. Effect of cold plastic deformation prior to ageing on creep resistance of an Al–Cu–Mg–Ag alloy // Mater. Sci. Forum. 2014. V. 794–796. P. 278–283.
Gazizov M., Kaibyshev R. Effect of pre-straining on the aging behavior and mechanical properties of an Al–Cu–Mg–Ag alloy // Mater. Sci. Eng. A. 2015. V. 625. P. 119–130.
Auld J.H. Structure of metastable precipitate in some Al–Cu–Mg–Ag alloys // Mater. Sci. Technol. 1986. V. 2. P. 784–787.
Kerry S., Scott V.D. Structure and orientation relationship of precipitates formed in Al–Cu–Mg–Ag alloys // Met. Sci. 1984. V. 18. P. 289–294.
Muddle B.C., Polmear I.J. The precipitation Ω phase in Al–Cu–Mg–Ag alloys // Acta Metall. 1989. V. 37. P. 777–789.
Abis S., Mengucci P., Riontino G. A study of the high-temperature ageing of Al–Cu–Mg–Ag alloy 201 // Philos. Mag. 1993. V. B67. № 4. P. 465–484.
Ringer S.P., Yeung W., Muddle B.C., Polmear I.J. Precipitate stability in Al–Cu–Mg–Ag alloys aged at high temperatures // Acta Metall. Mater. 1994. V. 42. P. 1715–1725.
Wang S.C., Starink M.J. Precipitates and intermetallic phases in precipitation hardening Al–Cu–Mg–(Li) based alloys // Int. Mater. Rev. 2005. V. 50. P. 193–215.
Зуйко И.С., Газизов М.Р., Кайбышев Р.О. Влияние термомеханической обработки на микроструктуру, фазовый состав и механические свойства сплава системы Al–Cu–Mn–Mg–Zr // ФММ. 2016. V. 117. № 9. С. 938–951.
Garg A., Howe J.M. Convergent-beam electron diffraction analysis of the Ω phase in an Al–4.0Cu–0.5Mg–0.5Ag alloy // Acta Metall. Mater. 1999. V. 39. P. 1939–1946.
Hutchinson C.R., Fan X., Pennycook S.J., Shiflet G.J. On the origin of the high coarsening resistance of Ω plates in Al–Cu–Mg–Ag alloys // Acta Mater. 2001. V. 49. P. 2827–2841.
Knowles K.M., Stobbs W.M. The structure of {111} age-hardening precipitates in Al–Cu–Mg–Ag alloys // Acta Crystallogr. 1988. V. 44. P. 207–227.
Kang S.J., Zuo J.-M., Han H.N., Kim M. Ab initio study of growth mechanism of omega precipitates in Al–Cu–Mg–Ag alloy and similar systems // J. Alloys Compd. 2018. V. 737. P. 207–212.
Kang S.J., Kim Y.W., Kim M., Zuo J.M. Determination of interfacial atomic structure, misfits and energetics of Ω phase in Al–Cu–Mg–Ag alloy // Acta Mater. 2014. V. 81. P. 501–511.
Gazizov M.R., Boev A.O., Marioara C.D., Holmestad R., Aksyonov D.A., Gazizova M.Yu., Kaibyshev R.O. Precipitate/matrix incompatibilities related to the {111}Al Ω plates in an Al–Cu–Mg–Ag alloy // Mater. Charact. 2021. V. 182. P. 111586.
Fonda R.W., Cassada W.A., Shiflet G.J.J. Accommodation of the misfit strain surrounding {III} precipitates (Ω) in Al–Cu–Mg–(Ag) // Acta Metall. Mater. 1992. V. 40. P. 2539–2546.
Gazizov M.R., Boev A.O., Marioara C.D., Holmestad R., Gazizova M.Y., Kaibyshev R.O. Edge interfaces of the Ω plates in a peak-aged Al–Cu–Mg–Ag alloy // Mater. Charact. 2022. V. 185. P. 111747.
Gazizov M., Kaibyshev R. High cyclic fatigue performance of Al–Cu–Mg–Ag alloy under T6 and T840 conditions // Trans. Nonferrous Met. Soc. China. 2017. V. 27. P. 1215–1223.
Золоторевский В.С. Механические свойства металлов. М.: МИСИС, 1998. 400 с.
Niesłony A., Dsoki C., Kaufmann H., Krug P. New method for evaluation of the Manson-Coffin-Basquin and Ramberg–Osgood equations with respect to compatibility // Int. J. Fatigue. 2008. V. 30. P. 1967–1977.
Lapovok R., Loader C., Torre F.H.D., Semiatin S.L. Microstructure evolution and fatigue behavior of 2124 aluminum processed by ECAE with back pressure // Mater. Sci. Eng. 2006. V. A425. P. 36–46.
Williams D.B., Carter B.C. Transmission Electron Microscopy: A Textbook for Materials Science. Springer, New York, 2009. 775 p.
Gazizov M.R., Belyakov A.N., Holmestad R., Gazizova M.Yu., Krasnikov V.S., Bezborodova P.A., Kaibyshev R.O. The deformation behavior of the {111}Al plates in an Al–Cu–Mg–Ag alloy // Acta Mater. 2023. V. 243. P. 118534.
Gazizov M., Kaibyshev R., Precipitation structure and strengthening mechanisms in an Al–Cu–Mg–Ag alloy // Mater. Sci. Eng. 2017. V. A702. P. 29–40.
Kamikawa N., Huang X., Tsuji N., Hansen N. Strengthening mechanisms in nanostructured high-purity aluminium deformed to high strain and annealed // Acta Mater. 2009. V. 57. P. 4198–4208.